Safety and Efficiency Agreement Information
Congratulations on your interest and investment in one of the most comprehensive service agreements available anywhere.
With this agreement, you are now a Preferred Customer which entitles you to the absolute priority service, extended warranties, cash discounts and most importantly peace of mind.
The purpose of this plan is to provide your family with the enhanced equipment safety and efficiency as well as extend the life of your equipment. Your family will also appreciate knowing that your equipment has been tested for deadly, odorless, poisonous carbon monoxide gas.
The agreement entitles you to benefit from our exclusive 23 point precision tune-up and professional cleaning (PTPC). Here is a list of our procedures.

• Clean, Level and calibrate thermostat
• Remove and wash blower & Fan assembly
• Wash condenser coil and evaporator coil when accessible.
• Replace and wash standard air-filters if supplied by customer.
• Lubricate all moving parts.
• Adjust all belts and pulleys
• Test all safety controls and devices.
• Test, Secure and tighten all electrical connections and terminals.
• Test humidifier operations and set damper, switches and valves.
• Clean Heat Exchangers, burners and pilot assemblies.
• Inspect heat exchanger(s), flue assembly, burners and draft diverters.
• Vacuum clean all combustion, flue and blower components.
• Adjust all main air dampeners.
• Activate heating and cooling systems.
• Test all motors, starting capacitors, run capacitors and potential relays.
• Test, measure and record operating temperature and pressures.
• Electronically test for poisonous deadly carbon monoxide gas.
• Test for gas leaks at furnace.
• Provide complete written analysis of our findings along with any recommendations that we may have.

Absolutely no risk Money-back Guarantee & Terms
All service department parts, materials and labor shall be discounted at a rate of 15% off of our normal price. Emergency service shall be provided after normal hours at no additional charge. All repair warranties under this agreement shall be doubled up to two full years, provided that you have maintained continual S.E.A coverage for the entire warranty period. This agreement will not automatically renew after each year. Your 100% satisfaction is guaranteed. Try this program for ninety days; if you are not pleased we will refund the entire investment. This is a no risk investment and will strike to keep you happy. Full payment is due upon acceptance of this agreement. Thank you very much for your investment. We are looking forward to service your needs.

16 point inspection
Cooling

• Take temperature splits.
• Check thermostats and remind customer to change thermostat batteries.
• Check duct system for debris when accessible.
• Check air-handler elbow for leaks.
• Check amp draws and voltages for all motors.
• Inspect drain lines and condensation pans.
• Check all electrical connections
• Check Evaporative coil
• Inspect compressor contactor.
• Check Compressor
• Check run capacitors.
• Inspect all wiring.
• Inspect disconnect.
• Check starting device.
• Check condensing coil.
• Check refrigerant pressure.
• Check filter and replace if customer supplies filter.

Heating

• Check temperature rise.
• Check thermostat
• Check amp draws and voltage of motors.
• Test heat-strips.
• Check defrost board.
• Check safety controls
• Inspect pilot-light and flame sensor.
• Test limit switches.
• Check gas and verify mixtures and burners.
• Check all electrical connections.
• Set anticipators.
• Check refrigerant pressures.
• Check filter and replace if customer supplies filter.
• Recommend CO2 detectors.
• Inspect heat-exchanges for cracks.